This device mounts on top of the elevator and when installed and wired correctly will allow the elevator to run with when the emergency escape hatch is closed and prevent it from running when the escape hatch is open. Because all elevator emergency escape switch hatches can vary from elevator to elevator, spacers, brackets may need to be made in the field to accommodate the various site specific requirements you may run into.
****PLEASE NOTE THIS DEVICE DOES NOT LOCK THE HATCH DOOR****
 |
 |
 |
- Sensor Type: Magnetic (Coded Magnet)
- Number of Circuits Controlled: 2
- Switch Starting Position: 1 Off (Normally Open) and 1 On (Normally Closed)
- Industry Designation: DPST-1NO/1NC
- Switching Current @ Voltage: 0.5 A @ 120 V AC/120 V DC
- Maximum Voltage: 120V DC/120V AC
- Input Voltage: 120V DC/120V AC
- Maximum Sensing Distance: 0.2"
- Wire Connection Type Wire: Leads
- Wire Leads Number of: 4
- Wire Length: 3 ft.
- Switch/Coded Magnet Length: 3.5"
- Width: 1"
- Height: 0.5"
- Housing Material: Plastic
- Fasteners Included: No
- Number of Holes: 4
- Hole Diameter: 0.2"
- Environment: Washdown, Temporary Submersion
- Environmental Rating: NEMA 4/12/4X/IP67
- Specifications Met: UL Listed, CSA Certified, CE Marked
- Required Products: Coded Magnets ***WILL NOT WORK WITH A REGULAR MAGNET***